BN Products BNG2000 Betreibershandbuch Seite 1

Page | 1Generator_Instruction_Manual • December 5, 2013 Gas Powered Generator Operator’s Manual BNG2000 (2KW)BNG3000 (3KW)BNG5000 (5KW)BNG6500 (6.5KW

Page | 10DO NOT touch hot muffler and AVOID hot exhaust gases. Allow equipment to cool before touching. Keep at least 5 feet (152 cm) of clearance on a

Page | 11main emissions compliant, high altitude adjustment is required. Operation without this adjustment will cause decreased performance, increased

Page | 126.2.3 ENGINE MAINTENANCEDANGER - When working on the generator, always disconnect spark plug wire from spark plug and keep wire away f

Page | 136.4 - VALVE CLEARANCEAfter the first 50 hours of operation, check the valve clearance in the engine and adjust if necessary.Important: If you

Page | 14• Replace the gasoline can if it has started to rust. Rust and/or dirt in the gasoline will cause problems with the carburetor and fuel syst

Page | 15SECTION 9 - TROUBLESHOOTINGProblem Cause CorrectionEngine is run-ning but no AC output is avail-able1.One of the circuit breakers is off.2.F

Page | 16

Page | 2ContentsINTRODUCTION ... 3SAFETY RULES ...

Page | 3INTRODUCTIONThank you for purchasing products by our company, we appreciate your business. The generator is a compact, high performance, air-c

Page | 4WARNING - This generator does not meet U.S. Coast Guard Regulation 33CFR-183 and should not be used in marine applications. Failure to use the

Page | 5• Keep at least 5 feet (1.5 m) of clearance on all sides of generator including overhead.• Replacement parts must be the same and installed

Page | 6• Refer to Figures to install wheels as shown.• Slide the axle through the frame brackets.• Slide on the wheel and flat washer, then assembl

Page | 7• Place generator on a flat, level surface.• Clean area around oil fill and remove oil fill cap and dipstick. Wipe dipstick clean.• Slowly fill

Page | 8WATTAGE REFERENCE GUIDETool or Appliance Running* (Rated) WattsAdditional Start-ing (Surge) WattsEssentialsLight Bulb - 75 watt75 —Furnace Fa

Page | 9Unplug all electrical loads from the unit’s receptacles before starting the engine. Make sure the unit is in a level position. Turn the Fuel S